Here's some more.
The left side of the receiver is held on by a screw. And a grub screw for the right side.
Now the trigger:
And on the inside:
All the parts laid out:
And the sears can levitate:
These guys won't ever see my gun again:
Here's the magwell(And it's two screws), the small grub screw secured the outer barrel:
The grub screw that secures the hopup unit:
And a empty barrel:
Here's the whole barrel assembly:
The top of the hopup unit:
Two grub screws for the arms, a o-ring for tension and a wide round nub:
The two grub screws secures the barrel to the hopup unit, and the plastic piece aligns the barrel(In a quite clever way):
Side by side some VSR barrels:
And that's my SDiK inside the barrel.
My SDiK is not long enough, as moving part moves too far forward:
Scaling things up:
If installing the SDiK, the spring guide stopper pipe, has to be reinstalled:
Don't like how mancraft made this part, the tube kinks when inside the cylinder(Some sort of L shaped insert, would have been nice):
With the stopper pipe back in place:
Fits over the trigger too:
The line can be routed out through the latch(Now less useless), but it does get pinched slightly:
That's a airsoftpro cylinder(VSR) fitted with a small buffer. The buffer makes it protrude a bit(Into the hole where the spring guide stopper fits)
But the buffer is only about 1mm thick, and the protrusion is more then that:
The piston and cylinder head:
.
