Join the silverback srs owners group on facebook, it's a highly discussed topic.

Apart from that it is really expensive, I've seen alot of reports of that the edgi cylinder is leaking at the nozzle. Only thing I've heard good about is the barrel.

Other options cylinder wise (well, piston) is the WASP and Faceless creepy piston with mousefart head. Only seen good things about those (apart from that they might be difficult to get).


Ps. Make an intro post 😉

 

EDGI makes some of the best quality precision machined parts out there. But its expensive as hell. His parts are definitely top notch.

 

Ultimately the parts still have to fit together. EDGI's nozzle is based on fitting _into_ the hopup bucking rather than against it, from what i can see.
This is not a new thing, stock nozzles sorta work this way also.


The good thing is that you will get consistent seal regardless of depth.
The bad thing is that it has to fit tight but not too tight (or it will get stuck etc) in the hopup bucking.


On the other end of the spectrum, there is the ASPUK conical nozzle.
It has incredible airseal because it just pushes against the bucking more or less.
But it also puts a lot of strain on the bucking.


EDGI isn't the golden bullet.

 

All day looking infarmation in closed fb group of srs owner. There was discussion that between piston head and nozle is airleaking gap. In this case there is problem that air seal is terrible. Person from egdi just showed that it can be fixes with thredlock. But there is no doubts, dual bore barrels from edgi is one of the best on the market! Probbably i will start from there. After looking info in group decided that on the market is better options than edgi piston, head and cilinder. I believe with all the information there and in fb gruop will find perfeck balance between accuracy and range. Stocked how many info there is! Thanks allot!! 👌