[bobgengeskahn]

Vindi:

I found some outer barrel extensions and am thinking that I am just going to use that with a suppressor to cover the inner barrel, plus itll give it a nice SD look

How did you stabilize the longer barrel in the fore-grip? I was thinking about getting a solid fore-grip and filling it with foam, but i love the look of the RIS grips

I rear wired my battery so I have a pouch on my stock but Im thinking about getting a LiPo and encasing the stock so it can still fold.

 

[woogie]

Find something that is the same size as your outter barrel... And make a mold with an old barrel inside. You will have some really nice tight spacers.

Get some sillicon mold stuff and use that.

 

[bobgengeskahn]

Woogie, I'm a little confused what youre getting at here... are you talking about a spacer between the inner and outer barrel?

What I'm doing is converting a G36c to a G36k... pretty much the same front end that vindi used. the problem is that if i just put a K front grip on then it still only has the C outer barrel support on there and about 9" of extra barrel hanging off of it. So im trying to think of a way to support between the outer barrel and the grip...

 

[vindicareassassin]

Vindi:

I found some outer barrel extensions and am thinking that I am just going to use that with a suppressor to cover the inner barrel, plus itll give it a nice SD look

How did you stabilize the longer barrel in the fore-grip? I was thinking about getting a solid fore-grip and filling it with foam, but i love the look of the RIS grips

I rear wired my battery so I have a pouch on my stock but Im thinking about getting a LiPo and encasing the stock so it can still fold.

Yer tiz

You need to use M5 bolts cut to length, so that they hold the inner tight and the bolt head sits tight against either the forestock or in my case the RIS rail.

Do this both sides and it holds the barrel firmly, and the forestock steady enough to fit a bi-pod.

You can just make out the C shaped marks where the bolts press against the barrel outer.

Also notice tha massive chunck taken out to enable a large stick 9.6v battery to fit when its got one of those massive C length forestocks on.

Barrel spacers made from plastic card bent into U shapes and then fed over the barrel, the sides were left long so the glue had something to grab hold of, but not to long to interfer with battery fit.

Again notice massive chunck missing to enable big kahoonas battery to be fitted

Appologies for shitty pics, been relegated to using my phone camera and it aint the best, though it ought to be the amount I'm payin for it

" title="" border="0"/> ~I managed to put my camera through the washing machine not once, but twice, so its not just fekd, its proper fekd

" title="" border="0"/>