there is only one vsr autobot. 60 is pretty soft.

 

Good point,

70 then, I was reading there was an AEG version, the person must be a muppet, my bad, I read it all wrong.

Thanks

 

there is an aeg version but it doesnt look like the vsr version. As long as the picture shows the vsr version and it says vsr or gbb you are good.

 

This was the description,

'New from Maple Leaf the Autobot Series of hop rubbers designed for GBB increase range.

Suitable for WE, Mauri and KJW a C ring is included for improved air seal but not necessary to install.'

 

Yeah thats the right one

 

Gone for a 75 degree,

 

That's way too hard unless you live in some super hot climate :hehe:

 

Struggling to find stock,

Either 60/70, will do yes?

 

Can find 60 in stock, but not 70..

 

There is no Autobot for AEGs. Autobot and Decepticon are for VSR-cut only. Yet there are AEG equivalents, but are called Macaron or "new monster", or whatever. Not autobot.

The Autobot will work great with an open type barrel and AA chamber, but you should combine them with the maple leaf nub, which ironically is marketed as "for AEG". Most places would have them listed as "Maple Leaf Omega", "Maple Leaf Ohm", or "Maple Leaf Hop Tensioner for AEG".

I would go with 70º, 60 is way too soft. I would prefer the 75 if 70 is not in stock.

 

There is no Autobot for AEGs. Autobot and Decepticon are for VSR-cut only. Yet there are AEG equivalents, but are called Macaron or "new monster", or whatever. Not autobot.

The Autobot will work great with an open type barrel and AA chamber, but you should combine them with the maple leaf nub, which ironically is marketed as "for AEG". Most places would have them listed as "Maple Leaf Omega", "Maple Leaf Ohm", or "Maple Leaf Hop Tensioner for AEG".

I would go with 70º, 60 is way too soft. I would prefer the 75 if 70 is not in stock.

Yes, thanks for clearing things up.

It is the autobot, with the Omega concave nub, and got an AA unit along with a open type barrel.

Will order soon!

 

I bought 60D Autobot for my BAR10 which shoots 180m/s and I was glad about that. Was really nice bucking, till one side of patch lip ripped off. Just a small small side. Considering that all was ok, but I think next time I will buy 70D.

 

Great choice!

I currently run a maple leaf autobot 70degree bucking and maple leaf concaver lever in my echo1 m28. I live in Brazil, so for me a 70degree worked perfectly. 515fps with .2g bbs. I use .45g bioattack bbs with the stock barrel. It just shoots perfectly. The "C ring" of the bucking helps a lot with air seal

 

Great!

I expect good things.